Video Tutorials - New - ACE

Video tutorials

How to use an Ecobite controller

Calibrate an Ecobite Controller

Detect a conveyor signal problem

1.4 How to navigate in the configuration menu

2.1 Adjusting Ecobite to detect the correct vehicle speed

2.2 Adjusting the conveyor's maximum speed

2.3 Adjusting the conveyor's minimum speed

2.4 Adjusting the conveyor boost

2.5 Calibrating the conveyor flow

2.6 Adjusting the spinner

2.7 How to verify the calibration of the conveyor flow

2.8 Conveyor Flow Calibration (MTQ Procedure)

Program an Ecobite controller

3.1 Activating and deactivating materials

3.2 Renaming a material

3.3.1 Adjusting the minimum and the maximum quantities for each material and variation steps

3.3.2 How to preprogram spreading rates with the S-PRG function

3.4.1 Using the manual mode for Ecobite version 4.4 and -

3.4.2 Using the manual mode for Ecobite version 4.4 and +

3.5.1 How to modify the rate and width of the blast in automatic mode

3.5.2 How to modify the speed of the conveyor and spinner for blast

3.5.3 How to adjust the duration of the blasts

3.5.4 How to adjust the minimum simulated speed for blasts

Detect a conveyor signal problem